Installing your Moto II Bar Clamp Mount

The Beeline Moto II Bar Clamp Mount has been redesigned for a cleaner look and improved durability. Follow this step-by-step guide to install it securely on your handlebars. 

What You’ll Need 

  • 1 x Metal bar clamp mount
  • Spacers for bar diameters: 22.2 mm, 25.4 mm, 28.6 mm, 31.8 mm 
  • 2x screws: 
    • 1 x M3 x 12 mm socket head screw (note: labelled “M4 x 12 mm” in early install guides) 
    • 1 x M4 x 8 mm countersunk screw 

Tools You’ll Need

Step-by-Step Installation 

1. Disassemble the mount 
 Your mount will arrive pre-assembled. Using a 2.5 mm hex key, remove the mount insert from the clamp. Loosen the clamp piece, keeping a hand under the mount to avoid losing screws. 

2. Select the correct spacer 
 Choose the shim that matches your handlebar diameter. Wrap it securely around your bar. 

3. Fit the clamp 
 Position the clamp over the shim, ensuring the teeth on the upper and lower halves align properly. 

4. Tighten the clamp 
 Insert the M3 x 12 mm screw and secure it with a 2.5 mm hex key. 

5. Refit the insert 
 Place the mount insert back into the cavity. Make sure it’s aligned so your Moto II locks in with the power button facing forward (riding position). Test the alignment before tightening. 

6. Secure the insert 
 Use a 3 mm hex key to fasten the M4 x 8 mm screw into the cavity. 

7. Ready to ride 
 Insert your Beeline Moto II, check it’s locked in securely, and you’re good to go!